Mám C2D E6300 a frekvence je na 1.4GHz. Je to normální, kdyyž je to 1,86? Zatím jsem netaktoval. Deska 945PL Neo3, paměti APACER 2x512 667.
Dík za radu
Tak ještě jednou
Moderátoři: PCMark, Awast, Moderátoři
A co bios ? Mas posledny ?
Apropo na MSI webe sa pise nieco taketo:
MSI Reminds You...
• According to the Intel North Bridge 945PL chipset spec, this board supports CPU of FSB 800MHz at maximum by default . However, you may let your board running at FSB 1066MHz (Core 2 Duo CPUs) by overclocking and adjusting the CPU FSB frequency in the BIOS:
Enter BIOS setup menu and go to [Cell_Menu] --> [Adjust CPU FSB Frequency]. There you can adjust the value to [266] for the Core 2 Duo E6300/E6400/E6600/E6700 CPUs. Please be noted that this is over-spec, and this overclocking behavior is not recommended and guaranteed.
*This is for PCB 2.2 only.
Ak moja anglictina je ok , treba proste pretaktovat FSB aby Ti cpu sluo na 1.86Ghz.
Apropo na MSI webe sa pise nieco taketo:
MSI Reminds You...
• According to the Intel North Bridge 945PL chipset spec, this board supports CPU of FSB 800MHz at maximum by default . However, you may let your board running at FSB 1066MHz (Core 2 Duo CPUs) by overclocking and adjusting the CPU FSB frequency in the BIOS:
Enter BIOS setup menu and go to [Cell_Menu] --> [Adjust CPU FSB Frequency]. There you can adjust the value to [266] for the Core 2 Duo E6300/E6400/E6600/E6700 CPUs. Please be noted that this is over-spec, and this overclocking behavior is not recommended and guaranteed.
*This is for PCB 2.2 only.
Ak moja anglictina je ok , treba proste pretaktovat FSB aby Ti cpu sluo na 1.86Ghz.
